DPR901 BSS
Dynamic Equaliser
DPR-901 II Dynamic Equaliser
The Dynamic Equaliser shall have four non-interactive bands of frequency-selective
compression or expansion. It shall be possible to use the unit as one nput/one output with
four bands, or as two inputs/two outputs with two bands of dynamic equalisation on each
section.
Each band shall provide a variable amount of dynamic EXPANSION up to +16dB or
COMPRESSION down to -30dB over a given BANDWIDTH around a particular FREQUENCY, whenever
the input signal reaches a certain THRESHOLD. Bandwidth, frequency and threshold
shall also be continuously variable independently for each frequency band.
Compression and expansion shall be continuously variable on a single control, having a
soft-knee dynamic characteristic at low settings which gradually progresses towards a
harder characteristic at maximum setting. This dynamic activity shall be selectable
on each band to affect signals BELOW the threshold only.
Attack and Release times shall be automatically programme controlled independently for
each band. The RELEASE profile shall be selectable FAST on each band to
disable the slower levelling stage of the release cycle.
Each frequency band shall have horizontal LED displays which continuously show the amount
of compression and expansion occurring whenever the signal level crosses the threshold. A
smaller vertical LED column shall continuously show input level relative to the THRESHOLD
setting.
The low and high frequency bands shall have BELL/SHELF selection, and the two midrange
bands shall have FILTER DEFEAT selection to allow either to perform broadband dynamic
control. Individual IN switches shall be provided for each band, in addition to an
overall system EQ IN switch. A system headroom indicator shall be provided to show signal
present, +10dBv, +15dBv and CLIP levels.
It shall be psossible to monitor the side chain of the unit, so that the effect of
the filter may be monitored as an aid to adjustment.
The dynamic equaliser shall be capable of operating at full line level up to +20dBv, with
a normal frequency response of +/-0.5dB 20Hz-20kHz. Output noise shall always
be less than -86dBv CCIR 468-2, and harmonic distortion shall be less than 0.05%. The
dynamic equaliser shall be capable of operating from a mains supply of 96v-132v or
192-260v AC 50/60Hz. The dynamic equaliser shall be standard 19" rack mount, 1U
(1¾") high. The Dynamic Equaliser shall be the BSS DPR-901 II.